Important Note: In Steps 10-17 the Calibration and Color Profiles must be named the same. Name it the same as step 12 - Leave all setting in their default unchecked state.Click the Plus Sign to create a new Color Profile.Name the Manual Cal "No Color Management_(resolution)" - or something else so that you know there is no curve applied.In the screenshot below, it's labeled "HP". Check the box next to Manual Calibration.Click the plus(+) sign to create a new Render Cong, and name it appropriately.Open the Navigator Configuration Editor.Start with a generic render configuration at the resolution desired. The following is where your ICC/ICM profile get input into the system.Ĭ:\Navigator\Navigator\Config\RenderConfig\ICC ProfilesĬreating the Render Config in the NCE that will be used to run the charts from the ICC profiling software: If you use SetGold to create the gray balance/linearization curve, then the following path is where you will place those files.Ĭ:\Navigator\Renderers\NR_1\SW\Config\Profiles\CMYK See section on applying a SetGold Profile and the SetGold users guide. This process takes more time, but it enables the user of the calibration process built into the DFE. Create a SetGold profile with a ICC profile.The disadvantage is the user will have to manually determine appropriate single-channel ink limits and it will be impossible to use the built-in calibration process. This is faster and easier because it omits the SetGold step. Create an ICC profile without a SetGold Calibration.This document is intended as a reference for technicians and advanced users already familiar with color management and the DFE system.
This article explains how to install and configure an ICC profile on a Navigator DFE system. Modified on: Mon, 30 Mar, 2020 at 3:12 PM Solution home Navigator DFE Reference and Support Documentation Installing and using ICC Profiles and Calibrations on a DFE system